SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-15
SNAX Error 00059SNAX Error 00059
Recovery. Specify a unique attribute value for each object. Note that some attributes
of switched lines affect the configuration of the PU attached to the line. To ensure that
the PU attached to a line is properly configured, delete the PU before altering the line
attributes. When the line configuration is stable, add the PU with properly verified PU
attributes.
SNAX Error 00059
Cause. An ALLOWOPENS or STOPOPENS command was issued to a remote LU
used for Advanced Program-to-Program Communications, a TLOGMGR LU, or an
ILOGMGR LU.
Effect. The command fails.
Recovery. ALLOWOPENS LU and STOPOPENS LU are valid only for local LUs used
for Advanced Program-to-Program Communication and acquired remote LUs. Check
the LU protocol and reissue the command to the appropriate LU.
SNAX Error 00062
Cause. The user attempted to add more than one remote PU to a secondary or
negotiable line.
Effect. The ADD command fails.
Recovery. Do not add more than one remote PU to a secondary or negotiable line.
SNAX Error 00063
Cause. The user attempted to alter the attributes of the local PU object, #ZNT21.
Effect. The ALTER command fails.
Recovery. Do not attempt to alter the local PU object.
SNAX Error 00064
Cause. The user attempted to stop a session without using the FORCED modifier in
the STOP SESSION command.
SNAX 3-00059 The command is not applicable to this type of
SNAX/APN LU.
SNAX E-00062 Only one SNAX/APN remote PU allowed.
SNAX E-00063 This command is not applicable
to SNAX/APN local PU
SNAX E-00064 Expecting FORCED modifier for STOP command.