SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-18
SNAX Error 00074
Recovery. An SNA SAP value must be in the range %H04 to %HFC and must be a
multiple of %h04. Choose a valid SAP value in the correct range and retry the
command.
SNAX Error 00074
Cause. An attempt was made to add or alter a PU on a Token-Ring or Ethernet line to
have a particular SAP value, but there were already MAXLS PUs with this same SAP
value; no additional PUs can have the same SAP value.
Effect. The command fails.
Recovery. Choose a different SAP value or increase the MAXLS value for the SAP.
SNAX Error 00076
Cause. The RECSIZE value specified in an ADD or ALTER LU command was too
large for the subtype of the line.
Effect. The command fails.
Recovery. Specify a RECSIZE value in the correct range for the line subtype, as
defined in Section 14, Attributes for SNAX/XF and SNAX/APN
SNAX Error 00077
Cause. The user attempted to change the CPNAME or the SNANETID attribute of the
SUBSYS object when resources were defined subordinate to the SUBSYS object.
Effect. The ALTER SUBSYS command fails.
Recovery. Delete all resources before attempting to alter these two attributes.
SNAX Error 00078
Cause. The user attempted to alter the SNANETID attribute of the remote PU object
when subordinate LUs had been defined under the PU.
SNAX E-00074 Number of PUs using specified SAP cannot exceed
line's SAPINFO value.
SNAX E-00076 RECSIZE value is too large for this line's
subtype.
SNAX E-00077 Cannot alter CPNAME/SNANETID name when
resources are defined.
SNAX E-00078 Cannot alter SNANETID when LUs are defined
on the PU.