SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-19
SNAX Error 00079SNAX Error 00079
Effect. The ALTER PU command fails.
Recovery. Delete the subordinate LUs before altering SNANETID.
SNAX Error 00079
Cause. The user specified the MAXRCVSIZE attribute without first specifying a
nonzero value for MAXLOCALLUS. MAXLOCALLUS is a required attribute that
enables SNAX/APN operation.
Effect. The command fails.
Recovery. Specify MAXRCVSIZE only when MAXLOCALLUS is nonzero.
SNAX Error 00080
Cause. The user attempted to configure SNAX/APN resources before using the
ALTER command to specify the SNANETID attribute for the SUBSYS object.
Effect. The command fails.
Recovery. Alter the SNANETID attribute of the SUBSYS object before configuring
other SNAX/APN resources.
SNAX Error 00081
Cause. An ADD or ALTER command was issued for a non-SNALU LU subordinate to
a SNAX/APN line. This error occurs for one of the following reasons:

An attempt was made to add a non-SNALU LU without specifying the SNANAME
attribute.

An attempt was made to alter a SNALU LU where PROTOCOL was changed from
SNALU to some other value and the SNANAME attribute was not already present
and it was not specified on the command.
Effect. The ADD or ALTER command fails.
Recovery. Specify SNANAME when configuring SNAX/APN LUs with PROTOCOL
values other than SNALU.
SNAX E-00079 MAXRCVSIZE is invalid when MAXLOCALLUS is 0
or not specified.
SNAX E-00080 SNANETID of the SUBSYS object must be
specified.
SNAX E-00081 SNANAME is a required attribute for SNAX/APN
non-SNALU LUs.