SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-20
SNAX Error 00082
SNAX Error 00082
Cause. The user specified the SNANETID attribute in an ADD or ALTER command for
a SNAX/APN local LU.
Effect. The command fails.
Recovery. The SNANETID attribute of local LUs is determined by the SNANETID
attribute specified for the SUBSYS object. Do not specify the SNANETID attribute in an
ADD or ALTER command for a local LU.
SNAX Error 00083
Cause. An ADD or ALTER command was issued that would cause the value of the
PASSTHRU or ASSOCIATE attribute to conflict with the value of the STATIC attribute.
This error occurs for one of the following reasons:

An attempt was made to add an LU with the STATIC attribute set to ON, but
without specifying PASSTHRU ON and ASSOCIATE lu-name.

An attempt was made to alter the PASSTHRU attribute to OFF or the ASSOCIATE
attribute to the null string when STATIC was set to ON.
Effect. The ADD or ALTER command fails.
Recovery. Specify both PASSTHRU ON and ASSOCIATE lu-name when STATIC is
set to ON. Set STATIC to OFF when trying to set PASSTHRU to OFF or when trying to
remove the value of ASSOCIATE.
SNAX Error 00084
Cause. An ADD or ALTER command was issued that would cause the value of the
PASSTHRU attribute to conflict with the value of the ASSOCIATE attribute. This error
occurs for one of the following reasons:

An attempt was made to add or alter an LU specifying ASSOCIATE lu-name, but
without specifying PASSTHRU ON.

An attempt was made to alter the PASSTHRU attribute to OFF when ASSOCIATE
lu-name was specified.
Effect. The ADD or ALTER command fails.
SNAX E-00082 Cannot change the SNANETID of a SNAX/APN local
LU.
SNAX E-00083 PASSTHRU and ASSOCIATE are required attributes
when using STATIC.
SNAX E-00084 PASSTHRU is a required attribute when using
ASSOCIATE.