SNAX/XF and SNAX/APN Configuration and Management Manual
Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-21
SNAX Error 00085SNAX Error 00085
Recovery. Specify PASSTHRU ON when trying to specify ASSOCIATE lu-name.
Remove the lu-name value of ASSOCIATE by specifying ASSOCIATE “” when trying
to set PASSTHRU to OFF.
SNAX Error 00085
Cause. In the SESSIONSELECT option in a TRACE command, one or more of the
specified fully qualified procedure correlation identifiers (FQPCIDs) did not represent
existing sessions.
Effect. The TRACE command might fail or it might continue to run, depending on the
position in the command of the SESSIONSELECT option that was in error. However,
the SESSIONSELECT option that was in error is not active.
Recovery. Ensure that all specified FQPCIDs represent existing sessions. You can
obtain the FQPCIDs for existing sessions by issuing the command LISTOBJECTS LU,
SUB ALL or LISTOBJECTS LU, SUB SESSION.
SNAX Error 00086
Cause. An SCF PRIMARY command was issued against a Line Handler Process and
the Line Handler Process could not switch the CPUs.
Effect. The command fails.
Recovery. None.
SNAX Error 00088
Cause. Adding an LU under a 2.0 PU requires both the ADDRESS and PROTOCOL
attributes.
Effect. The ADD command fails.
Recovery. Reissue the ADD LU command specifying both the ADDRESS and
PROTOCOL attributes
SNAX E-00085 Invalid FQPCID specified for SESSIONSELECT of
TRACE command.
SNAX E00086 The Line Handler Process rejected the SCF PRIMARY
command.
SNAX E-00088 Missing attribute