SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-25
SNAX Error 00118SNAX Error 00118
Recovery. Make sure APPN is set to YES when MAXLOCALLUS is non-zero.
SNAX Error 00118
Cause. The user specified the REGISTER attribute when NODETYPE is LEN or
NONE.
Effect. The command fails.
Recovery. Change the NODETYPE of SUBSYS to EN.
SNAX Error 00119
Cause. REGISTER attribute value mismatched with other LUs with the same
SNANAME.
Effect. The command fails.
Recovery. Make sure the value for REGISTER is the same.
SNAX Error 00120
Cause. (1) The NNSERVER attribute is specified with the value other than NONE
when NODETYPE is not EN; or (2) The NNSERVER attribute is specified in an ALTER
command.
Effect. The command fails.
Recovery. 1) Make sure the NODETYPE is EN when the NNSERVER attribute is
specified with MAIN, BACKUP or OTHER; or (2) Use the DELETE and ADD
commands to change the NNSERVER attribute.
SNAX Error 00121
Cause. The NNSERVER attribute of the PU being added matches an existing
adjacent node, but the CPNAME of the PU does not match the CPNAME of the
adjacent node.
SNAX E-00118 REGISTER attribute is not compatible with
NODETYPE of SUBSYS.
SNAX E-00119 REGISTER attribute value for SNAX/APN LUs with
same SNANAME must match one another.
SNAX E-00120 NNSERVER attribute is not compatible with
NODETYPE of SUBSYS or not allowed to alter.
SNAX E-00121 Same NNSERVER attribute must have the same
CPNAME specified.