SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-26
SNAX Error 00122
Effect. The command fails.
Recovery. Make sure the CPNAME of the PU matches the CPNAME of the adjacent
node that has the same NNSERVER attribute.
SNAX Error 00122
Cause. An attempt was made to configure the Service Manager Subsys ($SSCP) as:

NODETYPE EN without having installed the T0064 product, or

NODETYPE LEN without having installed either the T9564 or T0064 products.
Effect. The command fails and all future SNAX/APN functions will be rejected.
Recovery. Contact your HP Sales Representative to purchase the required product.
SNAX Error 00124
Cause. An attempt was made to ADD or ALTER a SNAX/APN LU with a TYPE and
PROTOCOL that are not compatible with each other.
Effect. The ADD or ALTER LU command fails.
Recovery. Reissue the ADD or ALTER command with compatible values for TYPE
and PROTOCOL.
SNAX Error 00125
Cause. An attempt was made to ALTER the STATION attribute on a SNAX/APN LINE.
Effect. The ALTER LINE command fails.
Recovery. Delete the line and re-add it with the new STATION value.
SNAX Error 00500
Cause. One of the attributes entered in a command was a duplicate. The name of the
attribute that was duplicated is attribute-name.
Effect. The command fails.
SNAX E-00122 SNAX/APN LEN or End Node function NOT installed
SNAX E-00124 The SNAX/APN LU TYPE and PROTOCOL are not
compatible
SNAX E-00125 The STATION attribute is not alterable
SNAX E-00500 Duplicate attribute attribute-name