SNAX/XF and SNAX/APN Configuration and Management Manual

WAN Subsystem Objects for SNAX Processes
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
2-7
SNAX Line Handler DEVICE Modifiers
example, if the system image was loaded from $SYSTEM.SYS01 and filename is
SNXSET, SNAX searches for $SYSTEM.SYS01.SNXSETO.
To change the SETTABNAME value, issue an SCF ALTER DEVICE command to the
WAN subsystem; for example:
STOP DEVICE $ZZWAN.#SSCP
ALTER DEVICE $ZZWAN.#SSCP, SETTABNAME MYSET
To temporarily override the WAN subsystem value in the SNAX subsystem, issue an
SCF ALTER SUBSYS command to change the SETTAB attribute value; for example:
ALTER SUBSYS $SSCP, SETTAB $SYSTEM.SET.TABLE
The ALTER SUBSYS command can only be used before adding subordinate SCF
objects but may specify a SET table on any volume and subvolume.
SSCPID n
SSCPID specifies a unique identifier for each SNAX service manager in an Expand
network. It is used only in SNAX/XF configurations, when the service manager
activates PUs.
To change the SSCPID value, issue an SCF ALTER DEVICE command to the WAN
subsystem; for example:
STOP DEVICE $ZZWAN.#SSCP
ALTER DEVICE $ZZWAN.#SSCP, SSCPID 1
To temporarily override the WAN subsystem value in the SNAX subsystem, issue an
SCF ALTER SUBSYS command; for example:
STOP SUBSYS $SSCP
ALTER SUBSYS $SSCP, SSCPID 1
SNAX Line Handler DEVICE Modifiers
COUNTRY n
COUNTRY specifies the translation tables used to translate from ASCII to EBCDIC
and EBCDIC to ASCII. COUNTRY is used only when SNAX applications use the
protocol CRT, ITI, or PRT.
Default: n = 0
Range: 1 through 65535
Default: n = 0 (United States and Canada)
Range: n = 0-358 (as given below)