SNAX/XF and SNAX/APN Configuration and Management Manual

SNAX/XF Primary Lines
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
3-5
Switched Line Using Permanently-Subordinated PU
and LU Objects
Switched Line Using Permanently-Subordinated PU and LU
Objects
One way to configure switched lines is to allocate PU and LU objects that are
permanently subordinated to a SNAX LINE object.
Figure 3-4 on page 3-6 shows an example of a switched line using permanently-
subordinated PU and LU objects. The SCF configuration, shown alongside, configures
the SNAX/XF LINE, PU, and LU objects.
Notes.
1. The X25AM SU must have PROTOCOL QLLC and DEVTYPE (58,20).
2. The SNAX/XF LINE object has SWITCHED ON.
3. ASSOCIATESUBDEV links the PU object with the SVC (SU object).
4. CALLVALIDATE BOTH on the PU object indicates validation of both the calling DTE
address and the connection identifier password in incoming calls.
5. For details of the SCF attributes for X25AM, see the SCF Reference Manual for X25AM.
Note. For remote node verification through SDLC exchange identifier (XID) frames when
multiple remote nodes connect at different times on the same line, you must use switched
floating PU and LU objects, as described on page 3-6.