SNAX/XF and SNAX/APN Configuration and Management Manual

SNAX/XF Secondary Lines
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
4-2
Configuring SNAX/XF Secondary Lines
.
For other types of line, see the examples in Section 3, SNAX/XF Primary Lines, but
add the LINE attributes STATION SECONDARY and APPLID and the LU attribute
PROTOCOL SNALU. Switched secondary lines also can use SNAX/CM.
Figure 4-1. Secondary Line
Notes.
1. A SNAX/XF line is configured as primary and nonswitched by default.
2. On SNAX/XF secondary lines, PU objects represent the NonStop system (PU type 2.0)
and LU objects represent gateway LUs within the NonStop system.
3. Secondary LINE objects must have STATION SECONDARY and APPLID (listing the host
applications you want to access from the NonStop system).
4. Secondary LU objects must have PROTOCOL SNALU.
5. For details of the SCF attributes for SNAX/XF, see the SCF Reference Manual for
SNAX/XF and SNAX/APN.
HOSTAPL1 HOSTAPL2 HOSTAPL3
SNA Host
NonStop System
$SSCP
SNA Communication
Controller
$SNAS1
PU
LU
NCP
VTAM
Secondary Line ($SNAS1)
SNAX/XF SCF Configuration
ADD LINE $SNAS1
, STATION SECONDARY
, APPLID (HOSTAPL1, HOSTAPL2, HOSTAPL3)
ADD PU $SNAS1.#PU001
, TYPE(13,2)
, RECSIZE 265
, MAXLUS 2
, ADDRESS %HC0
ADD LU $SNAS1.#LU001
, TYPE(14,0)
, PUNAME #PU001
, RECSIZE 1024
, PROTOCOL SNALU
, ADDRESS 1
START LINE $SNAS1, SUB ALL
SNAX Line
Handler
SWAN Concentrator
VST401.vsd