SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/XF Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
3-112
101: ZSX1-EVT-LINE-STATS-LIMIT
ZSX1-TKN-I-FRAME-RECV
is the number of DLC I-frames received.
ZSX1-TKN-I-FRAME-SENT
is the number of DLC I-frames transmitted.
ZSX1-TKN-PRIM-ABORT
is the number of times eight or more consecutive 1 bits were received.
ZSX1-TKN-REJ-RECV
is the number of DLC command rejects received.
ZSX1-TKN-REJ-SENT
is the number of DLC command rejects sent.
ZSX1-TKN-SNA-NEG-RSP
is the number of SNA negative responses sent.
ZSX1-TKN-TEST-RECV
is the number of TEST commands received without a valid FCS.
ZSX1-TKN-TEST-SENT
is the number of TEST commands received with a valid FCS and to which a TEST
response was sent.
ZSX1-TKN-WRITE-RETRIES
is the number of retransmissions of one or more DLC I-frames.
ZSX1-TKN-WRITE-TIMEOUTS
is the number of time-outs during WRITE operations.
Cause. A line statistics counter reached the limit set by the CNMA in a CNM SET
STATISTICS LIMIT command. This message is generated by the CS component of the
service manager.
Effect. The application should issue a CNM REQUEST STATISTICS command with
the reset bit set to 1 so that the command resets the limit values.
Recovery. The application should issue a CNM REQUEST STATISTICS command
with the reset bit on to reset the limit values.