SNAX/XF and SNAX/APN Event Management Programming Manual
SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-15
4: ZSX1-EVT-PC-REQ-ERR
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 in the SNAX/APN Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token described in the EMS Manual.
ZSX1-TKN-ENV-RESID
is the protocol-level ID. This token is described in Section 4, “Common Definitions”
in the SNAX/APN Management Programming Manual.
ZSX1-TKN-ENV-SIGNAL
is the dispatch signal.
ZSX1-TKN-ERRCODE
is the request error code.
Cause. A path-control request other than RESET or DISCONNECT was issued to
SNAX/APN level 2 while the PU address table was not initialized. This message is
generated by the level-3 protocol.
Effect. The request is ignored.
Recovery. If the I/O process can recover from the internal error, SNAX/APN continues
to run. If not, contact the Global Customer Support Center.
When contacting the Global Customer Support Center, provide all relevant information
as follows:
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing new programs
to run on D-series systems.