SNAX/XF and SNAX/APN Event Management Programming Manual

Introduction
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
1-5
Event Messages Sent by SNAX/XF
132 MESSAGE-SYSTEM-
INTERFACE-ERROR
The SNAX interface to the X.25 line handler
was unable to allocate message system queue
elements (MSQE) or message system control
blocks (MSCB).
PU Event Messages
41 PU-READY PU ready
42 PU-NOT-READY PU not ready
43 SW-PU-FAIL Switched PU failed
44 SW-PU-ERR Switched PU error
45 PU-ACTV PU active
46 PUID-NOT-FOUND Dial-in operation from a remote PU failed
47 PUID-MISMATCH Dial-in operation from a remote PU was
rejected
48 Not used
49 SW-SESSION-TIMEOUT Application failed after connection
117 ACT-PU-ERR ACTPU command failure
LU Event Messages
61 LU-ACTV SSCP-LU session active
62 LU-INACTV SSCP-LU session inactive
63 SW-LU-ERR Switched floating LU error
65 INCONS-LU-STATE Inconsistent LU state
66 TOO-MANY-INBND-BYTES Bytes sent exceeded file-system limit
67 Not used
Service-Manager Event Messages: General Events
71 SSCP-INTERNAL-ERR Service-manager internal error
73 SSCP-NO-POOL-SPACE Service manager cannot obtain buffer space
82 Not used
115 EXT-POOL-LIMIT EXTPOOLPAGES larger than maximum
allowed
116 INCONS-PTHRU-SESS-CNT Passthrough session count inconsistent
120 UNSUPPORTED-RU Unsupported request or response received
121 PIU-UNKNOWN-RESOURCE Request or response received from an
unknown resource
122 WRONG-PIU-MODE PIU is in the wrong mode
Table 1-1. SNAX/XF Event Messages (page 2 of 3)
Event
Number Symbolic Name (ZSX1-EVT-) Description