SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual426859-001
4-18
5: ZSX1-EVT-TS-INTERNAL-ERR
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 in the SNAX/APN Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token for C-series systems described in the EMS Manual.
ZSX1-TKN-ENV-RESID
is the protocol-level ID. This token is described in Section 4, “Common Definitions”
in the SNAX/APN Management Programming Manual.
ZSX1-TKN-CODE-LOC
is the address at which the error occurred.
ZSX1-TKN-STATE-EVT
is the state event that occurred.
Cause. An error occurred in an internal component of the line-handler process. This
message is generated by the level-4 protocol.
Effect. The system reports the problem and continues processing.
Recovery. Contact the Global Customer Support Center. Submit this and any other
related messages to your support representative along with a trace covering the
timestamp of the EMS message and a system dump with the trace active (if available).
When contacting the Global Customer Support Center, provide all relevant information
as follows:
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing new programs
to run on D-series systems.