SNAX/XF and SNAX/APN Event Management Programming Manual

Introduction
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
1-6
Event Messages Sent by SNAX/XF
123 UNFORMATTED-PIU Inconsistency occurred between line-handler
and service-manager processes
126 TRACE-STOPPED A line-handler or service-manager trace
stopped unexpectedly while writing trace data
to the extended data segment
127 Not used
128 Not used
129 Not used
130 Not used
131 Not used
Service-Manager Event Messages: LUNS Events
81 LUNS-ERR-CON LUNS error
Service-Manager Event Messages: CNM Events
91 ALERT Unsolicited alert
92 RTM-DATA Unsolicited RTM data received
Service-Manager Event Messages: CS Events
101 LINE-STATS-LIMIT Line statistics counter reached CNM-set limit
SPI Event Messages
111 SSGET-FAIL Error during SSGET call
112 SSINIT-FAIL Error during SSINIT call
113 SSNULL-FAIL Error during SSNULL call
114 SSPUT-FAIL Error during SSPUT call
Checkpointing Event Messages
124 CHECKPOINT-FAILED Checkpoint to backup service-manager
process failed
125 CHECKPOINT-INCOMPLETE Checkpoint to backup service-manager
process incomplete
Note. Most event messages with the ZSX1 subsystem ID can be generated by either
SNAX/XF or SNAX/APN, if both subsystems are running. Message numbers labeled “Not
used” in Table 1-1
are returned only for SNAX/APN operation. For full descriptions of all event
messages that SNAX/APN can generate, including information about the shared messages
that is relevant to SNAX/APN, refer to Section 4, SNAX/APN Event Messages.
Table 1-1. SNAX/XF Event Messages (page 3 of 3)
Event
Number Symbolic Name (ZSX1-EVT-) Description