SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-36
24: ZSX1-EVT-SW-LINE-ERR
ZSX1-TKN-PROCNAME
is the name of the line-handler process for the line on which the event occurred.
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 in the SNAX/APN Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number of the line. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token described in the EMS Manual.
ZSX1-TKN-STA-MODE
indicates whether the line is acting as a primary or a secondary station. This token is
described in Section 4, “Common Definitions” in the SNAX/APN Management
Programming Manual.
ZSX1-TKN-CAUSE-CODE
is the reason code for this error. The following are some valid reason codes:
For other values that this token can contain when SNAX/APN and SNAX/XF share
a line, refer to the SNAX/XF Management Programming Manual.
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing new programs
to run on D-series systems.
2 Indicates that a send call accept failed.
3 Indicates that a send call clear failed.
31 Indicates that no buffer space is available.
201 Indicates that the path is down.