SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-37
24: ZSX1-EVT-SW-LINE-ERR
ZSX1-TKN-LINE-STATE
indicates the line state. This token is described in Section 4 of the SNAX/APN
Management Programming Manual.
ZSX1-TKN-TRACE-STATE
indicates the trace state. This token is described in Section 4 of the SNAX/APN
Management Programming Manual.
Conditional Tokens
ZSX1-TKN-ERRCODE
is an error code that indicates why the event occurred. Possible values are as
follows:
Cause. An attempt to disconnect a switched line failed. This message is generated by
the service-manager process; it is used with event message 42.
Effect. The line is not available for use.
Recovery. Abort the line, then restart it. Because a switched line has only one
subordinate PU, you can safely use the ABORT command rather than the STOP
command.
0 Indicates that the operation was successful.
31 Indicates that no buffer space is available.
201 Indicates that the path is down.