SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-49
42: ZSX1-EVT-PU-NOT-READY
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 in the SNAX/APN Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token described in the EMS Manual.
ZSX1-TKN-FS-ERR
is a file-system error number (unless it equals 400 or 401) that indicates the reason
for the PU error. Some error numbers are as follows:
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing new programs
to run on D-series systems.
31 Indicates no buffer space.
33 Indicates that the I/O process is unable to obtain buffer space.
66 Indicates that a device is down.
140 Indicates a modem or link disconnect.
157 Indicates an I/O process internal error.
162 Indicates that an expected response from SNAXLink was not received. The
operation timed out.
164 Indicates that a disconnect was received.
172 Indicates that an invalid reply was received.
173 Indicates that the maximum number of retries is exhausted.
175 Indicates a command reject.