SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-53
43: ZSX1-EVT-SW-PU-FAIL
ZCOM-TKN-SUBJ-PU
is the fully qualified name of the PU for which this event occurred.
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-FALSE, indicating that this event is not a critical
event. This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 in the SNAX/APN Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token described in the EMS Manual.
ZSX1-TKN-CAUSE-CODE
indicates why the failure occurred. Some possible values are as follows:
ZSX1-TKN-PU-STATE
indicates the PU state. This token is described in Section 4, “Common Definitions”
in the SNAX/APN Management Programming Manual.
ZSX1-TKN-SW-STATE
has no meaning in a SNAX/APN environment.
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing new programs
to run on D-series systems.
21 Indicates that the send ADDPU failed.
22 Indicates that the ADDPU failed.
28 Indicates that the call failed.