SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-54
43: ZSX1-EVT-SW-PU-FAIL
ZSX1-TKN-TEST-STATE
indicates the current PU test state. This token is described in Section 4 of the
SNAX/APN Management Programming Manual.
ZSX1-TKN-ERRCODE
is an error code that indicates why the event occurred. Some possible values are as
follows:
Any other error number is a file-system error number, including the following error:
Conditional Tokens
ZSX1-TKN-BASE-ALIAS-LU
does not apply to SNAX/APN.
ZSX1-TKN-ASSOC-SUBDEV
does not apply to SNAX/APN.
Cause. A failure occurred when SNAX/APN attempted to contact or activate a
switched PU. This message is generated by the service-manager process.
Effect. The PU puname is not available for use.
Recovery. Recovery depends on the value of ZSX1-TKN-ERRCODE, as follows:
If ZSX1-TKN-ERRCODE is a file-system error number, refer to the Guardian
Procedure Errors and Messages Manual for information about the error.
If ZSX1-TKN-ERRCODE is 400, abort the PU, and then abort and restart the line.
If ZSX1-TKN-ERRCODE is 401, abort the line and then restart it.
If ZSX1-TKN-ERRCODE is 405, reconfigure the PU using a lower value for
ZMAX-LUS (in ZSX1-MAP-PU), and then restart the PU.
If ZSX1-TKN-ERRCODE is 408, reconfigure the line with a value for ZREC-SIZE
(in ZSX1-MAP-LINE) that is valid for the line type, then restart the line.
400 Indicates that the PU is not stopped.
401 Indicates that the PU is not started.
405 Indicates that MAXLUS has been exceeded.
408 Indicates that the line RECSIZE has been exceeded.
31 Indicates that no buffer space is available.