SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-66
48: ZSX1-EVT-XID-FAIL
0809 0041 A negotiation-proceeding XID3 was received when a prenegotiation XID3 was
expected.
0809 0042 On an asynchronous balanced mode (ABM) TG on which secondary-initiated
nonactivation exchanges are supported, the adjacent node initiated a
nonactivation exchange without explicitly indicating that it was doing so in the
ABM Nonactivation XID Initiator indicator in XID3.
0809 0045 The adjacent node formerly did not support the Exchange State indicators in
XID3, but its current XID3 indicates that it does.
0809 0046 The adjacent node formerly supported the Exchange State indicators in XID3,
but its current XID3 indicates that it does not.
0809 0047 An XID was received after the receipt of a mode-setting command but before
the completion of the mode-setting sequence (that is, before RR, RNR, or an
I-frame with the Poll bit set had been sent by the node with the primary link
station after it had received UA in response to its mode-setting command).
0809 0048 An NRM primary link station received an unsolicited XID from a normal
response mode (NRM) secondary link station.
0809 0049 An XID3 containing the XID Negotiation Error (X'22') was received by this
node.
0809 004E A node with an NRM secondary link station attempted to initiate a
nonactivation XID exchange with an XID3.
0809 0054 The adjacent node was expected to be a network node but indicated it was an
end node in its XID3, or vice versa.
0809 0055 A virtual routing node named in the received XID3 in the TG Identifier (X'80')
subfield of the TG Descriptor (X'46') control vector was not defined on the
receiving filter.
0812 0019 Insufficient storage was available to conduct an XID exchange.
0812 001A Insufficient storage was available to activate a TG.
0812 001B Insufficient storage was available to activate a Token-Ring connection.
083E 0001 The limit for link activation XID exchanges was exceeded.
083E 0002 The limit for nonactivation XID exchanges was exceeded.
086F 0000 The control vector length field was invalid or control vector fields were
incompatible.
088C 0Eyy Network Name (X'0E') control vector of type yy was missing.
088C 1000 The Product Set ID (X'0E') control vector was missing.
0891 0004 The Net ID in the Network Name (X'0E', CP name) control vector was invalid.
0891 0005 The Control Point (CP) name in the Network Name (X'0E', CP name) control
vector was invalid.
0895 xxyy The Control vector with key xx at byte offset yy in XID3 was in error.
Table 4-1. Sense Data Values for Event Message 48 (page 2 of 4)
Sense
Data Value Description