SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-91
82: ZSX1-EVT-XLF-LOGON-ERR
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 in the SNAX/APN Management Programming Manual.
ZSX1-TKN-SNANAME
is the SNA name of the remote LU.
ZSX1-TKN-ERRCODE
indicates the reason for the failure. The possible values for error are as follows:
Cause. A remote logon attempt or an attempt to acquire a remote 3270 device failed.
Possible causes for the failure are as follows:
•
If error is 2, the ZSX1-TKN-SET-TBL token either was not specified in an ALTER
SUBSYS command or was assigned an invalid value in ALTER SUBSYS.
•
If error is 10, a duplicate name was specified for an acquired remote LU.
•
If error is 14, the subdevice name configured in the ZSX1-TKN-CREATOR token
for the TLOGMGR LU did not match the subdevice-name part of the
SNAX Creator-2 APPL object name.
•
If error is 31, insufficient buffer space was available to process the device logon or
device acquire.
•
If error is 184, the attempted device logon failed because the Creator-2 application
is not active.
•
If error is 2913, the attempted device logon or device acquire would cause the total
number of LUs under the remote PU to exceed the configured ZMAX-LUS value.
Effect. The device logon or device acquire fails.
Recovery. Recovery depends on the value of error, as follows:
•
If error is 2, specify a valid value for ZSX1-TKN-SET-TBL in an ALTER SUBSYS
command.
•
If error is 10, ensure that each LU has a unique name.
2 Invalid operation.
10 Name already exists.
14 No such device.
31 No buffer space available.
184 Creator-2 not started
2913 ZMAX-LUS limit exceeded in ZSX1-MAP-PU for remote PU.