SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-138
130: ZSX1-EVT-ELF-NAME-NOT-FOUND
ZEMS-TKN-SUBJECT-MARK
is the standard EMS token that always immediately precedes the subject token.
In this event message, the subject token is ZCOM-TKN-SUBJ-LINE.
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-FALSE, indicating that this event is not a critical
event. This token is described in the EMS Manual.
ZSX1-TKN-SENSE-CODE
indicates the reason for the failure. The values for reason code are as follows:
Reason Code 00000001
Cause. A LOCATE-CDINIT was received that did not contain either a SLU Name
or an APPL Name or it contained neither of them.
Effect. The logon request is rejected.
Recovery. Because the LOCATE-CDINIT was generated in the IBM network, a
person responsible for the sending node must determine and correct the problem.
Reason Code 00000016
Cause. Internal error.
Effect. The logon request is rejected.
Recovery. Retry the logon. If the problem persists, contact the Global Customer
Support Center (GCSC).
Reason Code 00000017
Cause. Internal error.
Effect. The logon request is rejected.
Recovery. Retry the logon. If the problem persists, contact the Global Customer
Support Center (GCSC).
ZSX1-TKN-LOCALSNANAME
is the SCF APPL name of the Compaq application that is the target of the logon
request.
ZSX1-TKN-SNANAME
is the SNA name of the SLU, in the IBM network, requesting the logon.
ZCOM-TKN-SUBJ-LINE
is the fully qualified name of the SNAX/APN line that received the logon request.