SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-141
132: ZSX1-EVT-MS-PROC-ERR
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-FALSE. This token is described in the EMS Manual.
ZCOM-TKN-SUBJ-LINE
is the fully qualified name of the SNAX Over X.25 line-handler process that
generated the event.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 of the SNAX/XF Management Programming Manual.
Conditional Tokens
ZCOM-TKN-SUBJ-PU
is the fully qualified name of the PU that experienced the failure.
ZSX1-TKN-ASSOC-SUBDEV
is the name of the X.25 line-handler associated with the SNAX Over X.25 line.
ZSX1-TKN-MSCB
is present if the error was a failure to allocate message system control blocks
(MSCB).
ZSX1-TKN-MSQE
is present if the error was a failure to allocate message system queue elements
(MSQE).
Cause. An X.25 line-handler was unable to allocate message system queue elements
(MSQE) or message system control blocks (MSCB).
Effect. The PU is deactivated.
Recovery. If the PU is on a SNAX leased line (X.25 permanent virtual circuit-PVC)
and the PU’s L3TIMEOUT value is non-zero, the PU is reactivated automatically.
If the PU is on a SNAX switched line (X.25 switched virtual circuit-SVC), the
PU/PORT virtual circuit must be reconnected. When this is completed, the PU is
automatically reactivated, provided that its L3TIMEOUT value is non-zero.