SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/APN Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
4-154
306: ZCL2-EVT-ET-FRMR
•
An unsolicited U-frame response
•
An invalid S-frame command or response
•
An unsolicited I-frame or S-frame response
•
%h03: the rejected frame is one of the following:
•
An S-frame that is more than 2 bytes long
•
A FRMR was received with an information field that was not 5 bytes long
•
%h04: the rejected frame is an I-frame that is longer than the rejecting station’s
receive buffers. This error can be caused by a mismatch between line’s
RECSIZE attribute and the corresponding configuration parameter specified for
the remote station.
•
%h08: the rejected frame is an I-frame or an S-frame that contains an invalid
N(r) value. This error can be caused by a mismatch between line’s LNMAXIN
attribute and the configuration parameter for the remote station that specifies the
maximum number of I-frames that can be sent without receiving an
acknowledgment.
%h11: the rejected frame is an I-frame that contains an invalid N(s) value. This error
can be caused by a mismatch between line’s LNMAXOUT attribute and the
configuration parameter for the remote station that specifies the maximum number
of I-frames that can be received without sending an acknowledgment.
Cause. This message indicates that SNAX Over Ethernet either sent or received a link
level Frame Reject (FRMR) response. SNAX Over Ethernet will attempt to continue.
Effect. This message is informational if the SNAX Over Ethernet PU continues to
function. Otherwise, the SNAX Over Ethernet PU enters the stopped state.
Recovery. Contact the Global Customer Support Center for assistance.