SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/XF Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
3-24
8: ZSX1-EVT-BKUP-NOTUP
error codes can be found in the ServerNet Communications Configuration and
Management Manual.
ZSX1-TKN-ERRCODE-DETAIL
is the code for the error detail. The error detail codes can be found in the Guardian
Procedure Errors and Messages Manual.
Cause. The primary SNAX line-handler or service-manager process is unable to start
its backup process.
Effect. The SNAX/XF device does not have fault-tolerant capabilities at this time.
Recovery. Verify that you specified a valid backup CPU number in the programmatic or
SCF ADD DEVICE command. Correct any problem indicated by the error codes. To
ensure that the SNAX/XF device has fault-tolerant capabilities, issue a STOP DEVICE
command, then issue ADD DEVICE and START DEVICE requests to the WANMGR,
specifying a valid backup CPU.