SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/XF Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
3-31
23: ZSX1-EVT-LINE-DOWN
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 of the SNAX/XF Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number of the line. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token described in the EMS Manual.
ZSX1-TKN-FS-ERR
is a file-system error number that indicates why this error occurred. Some possible
error numbers are as follows:
ZSX1-TKN-STA-MODE
indicates whether the line is acting as a primary or a secondary station. This token is
described in Section 4, “Common Definitions” in the SNAX/XF Management
Programming Manual
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing programs to
run on D-series systems or later systems.
40 Indicates an operation timeout.
66 Indicates that a device is down.
122 Indicates data loss.
140 Indicates a modem/link disconnect.
157 Indicates an I/O process internal error.
190 Indicates a device error.
218 Indicates an interrupt timeout.