SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/XF Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
3-35
24: ZSX1-EVT-SW-LINE-ERR
ZSX1-TKN-LINE-STATE
indicates the line state. This token is described in Section 4 of the SNAX/XF
Management Programming Manual.
ZSX1-TKN-TRACE-STATE
indicates the trace state. This token is described in Section 4 of the SNAX/XF
Management Programming Manual.
Conditional Tokens
ZSX1-TKN-ERRCODE
is an error code that indicates why the event occurred. Possible values are as
follows:
Cause. An attempt to disconnect a switched line failed. This message is generated by
the service-manager process; it is used with event message 42.
Effect. The line name is not available for use.
Recovery. Abort the line, and then restart it. Because a switched line has only one
subordinate PU, you can safely use the ABORT command rather than the STOP
command.
31 Indicates that no buffer space is available.
43 Indicates that an ACTLU command failed.
201 Indicates that the path is down.
0 Indicates that the operation was successful.
31 Indicates that no buffer space is available.
201 Indicates that the path is down.