SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/XF Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
3-48
43: ZSX1-EVT-SW-PU-FAIL
ZCOM-TKN-SUBJ-PU
is the fully qualified name of the PU for which this event occurred.
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-FALSE, indicating that this event is not a critical
event. This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 of the SNAX/XF Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token described in the EMS Manual.
ZSX1-TKN-CAUSE-CODE
indicates why the failure occurred. Some possible values are as follows:
ZSX1-TKN-PU-STATE
indicates the PU state. This token is described in Section 4, “Common Definitions”
in the SNAX/XF Management Programming Manual.
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing new programs
to run on D-series systems or later systems.
21 Indicates that the send ADDPU failed.
22 Indicates that the ADDPU failed.
23 Indicates that the REQCONT (request contact) failed.
28 Indicates that the call failed.