SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/XF Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
3-53
44: ZSX1-EVT-SW-PU-ERR
ZSX1-TKN-ERRCODE
is an error code that indicates why the event occurred. Some possible values are as
follows:
Any other error number is a file-system error, including the following errors:
Conditional Tokens
ZSX1-TKN-BASE-ALIAS-LU
is the name of the SNAX Connection Manager (SNAX/CM) alias LU name used.
This token is described in Section 4, “Common Definitions” in the SNAX/XF
Management Programming Manual.
ZSX1-TKN-ASSOC-SUBDEV
is the name of the X25AM SU object when using SNAX/CM on multiple X.25
lines.
Cause. An error occurred when SNAX/XF attempted to add or contact a switched PU
(permanently subordinated or switched floating). This message is generated by the
service-manager process.
Effect. The specified PU cannot be used.
Recovery. If ZSX1-TKN-ERRCODE is a file-system error number, refer to the
Guardian Procedure Errors and Messages Manual for corrective action based on the
indicated error.
If ZSX1-TKN-ERRCODE is 400, abort the PU, and then abort and restart the line.
If ZSX1-TKN-ERRCODE is 401, abort the line and then restart it.
400 Indicates that the PU is not stopped.
401 Indicates that the PU is not started.
31 No buffer space is available.
201 The current path to the device is down, the device is nonexistent, or there is
an error in the message-system interface.