SNAX/XF and SNAX/APN Event Management Programming Manual

SNAX/XF Event Messages
SNAX/XF and SNAX/APN Event Management Programming Manual—426859-001
3-67
61: ZSX1-EVT-LU-ACTV
ZSPI-TKN-MANAGER
is the name of the service-manager process (the SUBSYS object name), as described
in Section 3 of the SNAX/XF Management Programming Manual.
ZEMS-TKN-LDEVNUMBER
identifies the logical device number. This is the 32-bit equivalent of
ZEMS-TKN-LDEV.
ZEMS-TKN-XLDEVNAME
is the string equivalent of the logical device number.
ZEMS-TKN-LDEV
is a standard EMS token described in the EMS Manual.
ZSX1-TKN-LU-TYPE
indicates the LU session type. This token is described in Section 4 of the SNAX/XF
Management Programming Manual.
ZSX1-TKN-LU-SESS-STATE
indicates the SSCP-LU session state. This token is described in Section 4 of the
SNAX/XF Management Programming Manual.
ZSX1-TKN-LU-STATE
indicates the LU session state. This token is described in Section 4 of the SNAX/XF
Management Programming Manual.
ZSX1-TKN-LU-ADDR
is the LU address.
Cause. An SSCP-LU session became active. This message is generated by the service
manager.
Effect. The specified LU is available for use. The system waits for the next command.
Recovery. This is an informative message only; no corrective action is needed.
Note. Although ZEMS-TKN-LDEV is included in the event message, you should use the
ZEMS-TKN-LDEVNUMBER and ZEMS-TKN-XLDEVNAME tokens when writing new programs
to run on D-series systems or later systems.