SNAX/XF LU Network Services Manual

Messages and Codes
ESS System Messages
097841 Tandem Computers Incorporated B–3
" ESS TABLE RECORD NOT FOUND FOR THIS COMMAND --> S0002 "
Cause
An ESS table record whose record name matches the failing command was not
found in the terminal’s ESS table.
Effect
The failing command is ignored and the terminal’s keyboard is reset to allow the
entry of another command.
Recovery
Verify that the command is being entered correctly and correct it if not.
If the command is being entered correctly, the ESS table currently assigned to the
terminal is either the wrong table or it does not contain a record whose record
name matches the failing command. If necessary, see “Finding an Assigned ESS
Table” earlier in this appendix.
If the correct ESS table was assigned to the terminal, use SNAXUTL to add the
desired record to the terminal’s ESS table.
If the wrong ESS table was assigned to the terminal, temporarily assign the correct
one using the SCF ALTER LU terminal-lu-name , ESSTABLE ess-table-
name command. A permanent correction might be necessary to the SCF ADD LU
command that created the LU. If line or PU default values are employed for the
ESSTABLE attribute of the LU, check the ADD PU and ADD LINE commands
which created the LU’s PU and line and correct them if necessary.
" SEQUENCE ERROR--> S0006 "
Cause
The failing command was not in the correct sequence.
For example, the command requested a logoff and the terminal was not logged on
to an application.
Effect
The failing command is ignored and the terminal’s keyboard is reset to allow the
entry of a valid command.
Recovery
Enter a valid command.