SNAX/XF LU Network Services Manual

Messages and Codes
ESS System Messages
B–12 097841 Tandem Computers Incorporated
" CREATOR NOT DEFINED --> S0029 "
Cause
A Tandem Creator process has been defined for this TACL or Pathway application
through the CREATOR attribute in an SCF ADD/ALTER APPL command. An
attempt has been made to communicate with the Creator process to have it start
the TACL or Pathway application; however, the Creator process has not been
defined by an SCF ADD APPL command.
Effect
The failing command is ignored and the terminal’s keyboard is reset to allow the
entry of another command.
Recovery
Use the SCF INFO APPL application-subdevice-name command to display
the CREATOR attribute for the application. The application-subdevice-
name is specified in the PLUNAME field of the ESSCMD record. If necessary, see
“Finding an Assigned ESS Table” earlier in this appendix.
Either correct the CREATOR attribute or define the Creator process to LUNS using
an SCF ADD APPL command.
" CREATOR NOT CONNECTED --> S0030 "
Cause
A Tandem Creator process has been defined for this TACL or Pathway application
through the CREATOR attribute in an SCF ADD/ALTER APPL command. An
attempt has been made to communicate with the Creator process to have it start
the TACL or Pathway application; however, the Creator process has not issued a
CONNECT request to LUNS.
Effect
The failing command is ignored and the terminal’s keyboard is reset to allow the
entry of another command.
Recovery
Use the SCF INFO APPL application-subdevice-name command to display
the CREATOR attribute for the application. The application-subdevice-
name is specified in the PLUNAME field of the ESSCMD record. If necessary, see
“Finding an Assigned ESS Table” earlier in this appendix.
Check that the Creator process has been started. If the Creator process was active
at the time of the failure, contact your Tandem representative.