SNAX/XF LU Network Services Manual

Numbered Creator Process Messages
Creator Process Error Messages
097841 Tandem Computers Incorporated C–11
Creator Process Error 023PAT
CP023PAT - PATHWAY RUN PROGRAM error
PATHMON Name = $ PATHMON-name
Program Name = program-name
PATHWAY Error = error
PATHWAY Info = info
Tandem Name = Tandem-name
Cause
The program name was not added to the Pathway configuration file.
Effect
The $ PATHMON-name value is the name of the PATHMON. The program-name
value is the Pathway object name. The error and info values contain
additional information about the Pathway error. The Tandem-name value is
returned in the form $ line-name. # lu-name .
Recovery
Verify that the names specified for Pathway in the logon record are the same as
were specified in the Pathway configuration file. Refer to the PATHWAY
PATHCOM Reference Manual for information on the error and info values.
Perform appropriate action as needed.
Creator Process Error 024MIS
CP024MIS - Takeover by backup Creator
CHECKPOINT Status <0:7> = status-field
CHECKPOINT Status <8:15> = status-field
Cause
The primary Creator process has failed, and the backup Creator process has taken
control.
Effect
The status field values are bits <0:7> and <8:15> that are returned in the
status parameter of the CHECKPOINT procedure call. For explanations of these
status codes, consult the syntax description in the Guardian Procedure Calls
Reference Manual.
Recovery
This is an informational message only; no action is necessary.