SNAX/XF LU Network Services Manual

SNAXUTL Error Messages
SNAXUTL Error Messages
E–22 097841 Tandem Computers Incorporated
Try the operation again. If the problem persists, consult your Tandem
representative.
SNAXUTL ERROR NUMBER: 6420
An error occurred during the open of $SSCP.#SNAXUTL. Check to see that
SNAXUTL has been added through an ADD APPL command (such as ADD APPL
$SSCP.#SNAXUTL, APPLTYPE LUNSAPPL, PASSWORD “SNAXUTL”).
SNAXUTL ERROR NUMBER: 6430
A WRITEREAD error occurred during a CONNECT request to LUNS.
Check that SNAXUTL was added as an APPL with PASSWORD “SNAXUTL”
Remember that passwords must be right-filled with blank spaces, up to a total of
eight characters.
SNAXUTL ERROR NUMBER: 6440
LUNS has returned an error in response to a CONNECT request.
Check that SNAXUTL was added as an APPL with APPLTYPE LUNSAPPL.
SNAXUTL ERROR NUMBER: 6450
A WRITEREAD error occurred while a deactivation request was being sent to
LUNS.
Try the operation again. If the problem persists, consult your Tandem
representative.
SNAXUTL ERROR NUMBER: 6460
LUNS returned an error in response to a deactivation request.
Check that the ESS file named on the SELECTFILE command does not conflict
with file names that are not ESS table file names.
SNAXUTL ERROR NUMBER: 6470
A WRITEREAD error occurred while an activation request was being sent to
LUNS.
Try the operation again. If the problem persists, consult your Tandem
representative.
SNAXUTL ERROR NUMBER: 6480
LUNS returned an error in response to an activation request.
Try to use the ESS table named in the SELECTFILE command. If the message
“ESS TABLE TEMPORAILY DEACTIVATED BY SNAXUTL” is displayed, issue
the following SCF command:
ALTER SUBSYS $SSCP,SETTAB table-name
where table-name is the name of the currently active SET table.
If the problem persists, consult your Tandem representative.