SNAX/XF LU Network Services Manual

New and Changed Information
097841 Tandem Computers Incorporated iii
In addition to editorial changes, the following information has been changed in this
manual:
Throughout the manual, the term “logical name” has been replaced. Where
logical name referred to a Tandem subdevice name, it has been replaced by the
term “subdevice name.” Where logical name referred to a name configured on a
host system, it has been replaced by the term “SNA name.”
A subsection titled “The Creator and SNAX Creator-2 Processes” has been added
to Section 1, “Introduction to LUNS.”
In Section 2, “Using LUNS,” the subsection titled “The ADD APPL Command”
has been rewritten. There are now four separate subheadings: “ADD APPL
Command for TACL Processes,” “ADD APPL Command for the Creator Process,”
and “ADD APPL Command for SNAXUTL.”
The SCF attribute CRYPTOTYPE has been deleted from Section 2, “Using LUNS.”
This attribute is no longer supported.
The SNAXUTL ADD ESSCMD operand TERMSELF ON has been added to
Appendix A, “SNAX/XF Utility.” The use of this operand is also described in
Section 2, “Using LUNS.”
The SNAXUTL ADD ESSCMD operand CRYPTOTYPE has been deleted from
Appendix A, “SNAX/XF Utility.” This operand is no longer supported.
Appendix B, “LUNS Messages and Codes, “ has been retitled “ESS System
Messages.” The subsection titled “LUNS Internal Messages and Codes,” has been
deleted from it. The messages this subsection contained are now included in the
description of EMS event message 81 in the Operator Messages Manual.
ESS system message S0052 has been deleted from Appendix B, and ESS system
messages S0018, S0053 S0054, and S0055 have been added.
Appendix G, “D-Series Systems Information,” has been deleted. D-series
information is now included under the heading “Creator Process RUN Command
Syntax” in Section 2, “Using LUNS,” and in Appendix C, “Creator Process Error
Messages.”
New definitions have been added to the glossary.
The index has been updated.