SNAX/XF LU Network Services Manual

SNAXUTL ADD Commands
The SNAX/XF Utility
097841 Tandem Computers Incorporated A–7
GATELINE gateway-line
specifies the gateway line to be used when communicating with the SNA host.
This parameter is required if the SENDHOST parameter is specified and the SNA
host is a remote system; if the line is connected to a local system, this parameter is
optional. The format for gateway-line is:
[\ system-name .]$ device-name
where:
system-name
is the name of the system on which the gateway line resides. This value
can be from one to seven alphanumeric characters long, where the first
character is alphabetic.
device-name
is the device name corresponding to the line. This value can be from one
to seven alphanumeric characters long, where the first character is
alphabetic.
Note that GATELINE should not be specified when either GATEPU or GATELU is
specified.
GATEPU gateway-pu
specifies the gateway physical-unit name that is to be used when this command is
sent to the SNA host. The format of gateway-pu is:
[\ system-name .]$ device-name .# pu-name
where:
system-name
is the name of the system on which the gateway physical unit resides.
This value can be from one to seven alphanumeric characters long, where
the first character is alphabetic.
device-name
is the device name corresponding to the line. This value can be from one
to seven alphanumeric characters long, where the first character is
alphabetic.