SNAX/XF LU Network Services Manual

SNAXUTL ADD Commands
The SNAX/XF Utility
A–16 097841 Tandem Computers Incorporated
TSPROF ts-profile-value
specifies the transmission services profile (byte 3 of the BIND image). Any
hexadecimal number in the range of %H00 to %HFF can be specified for ts-
profile-value .
The default value is %H03.
PRIPROT priprot-value
specifies the primary LU protocol (byte 4 of the BIND image). Any hexadecimal
number in the range of %H00 to %HFF can be specified for priprot-value .
The default value is %HB1.
SECPROT secprot-value
specifies the secondary LU protocol (byte 5 of the BIND image). Any hexadecimal
number in the range of %H00 to %HFF can be specified for secprot-value .
The default value is %H90.
COMPROT comprot-value
specifies the common LU protocols (bytes 6 and 7 of the BIND image). Any
hexadecimal number in the range of %H0000 to %HFFFF can be specified for
comprot-value .
Note that the required value for 6530 devices is %H7080.
The default value is %H3080.
SSNDPAC ssndpac-value
specifies the secondary receive pacing count (byte 8 of the BIND image). Any
hexadecimal number in the range of %H00 to %H3F can be specified for
ssndpac-value .
The default value is %H00.
Note that SNAX/XF does not support pacing. Therefore, any value specified
other than the default of %H00 will be treated by SNAX/XF as if the default of
%H00 was specified.
SRCVPAC srcvpac-value
specifies the secondary send pacing count (byte 9 of the BIND image). Any
hexadecimal number in the range of %H00 to %H3F can be specified for
srcvpac-value .
The default value is %H00.
Note that SNAX/XF does not support pacing. Therefore, any value specified
other than the default of %H00 will be treated by SNAX/XF as if the default of
%H00 was specified.