SNMP Configuration and Management Manual

Installing and Configuring the SNMP Agent
SNMP Configuration and Management Manual—424777-006
2-44
Multiple-Host Connections
In Figure 2-9, the SNMP agents on nodes \A, \B, and \C accept requests from either
SNMP manager, but only send traps to the manager whose internet address is
130.25.86.4. Following are the SCF commands used to configure connections for this
scenario. Note that the SNMP agent on node \B uses the default NETWORK attribute
value in its TRAPDEST object definition:
SYSTEM \B
ASSUME PROCESS $ZSNMP
STOP ENDPOINT #DEFAULT
ALTER ENDPOINT #DEFAULT, HOSTADDR 130.25.86.2
START #DEFAULT
ADD TRAPDEST #STA2, HOSTADDR 130.25.86.4
START TRAPDEST #STA2
Figure 2-9. Multiple SNMP Agents, Multiple Host Connections
\B
\C
SNMP
Agent
($ZSNMP)
\A
SNMP Manager 2
(at 130.25.86.4)
130.25.86.1 130.25.86.2
130.25.86.3
SNMP Manager 1
(at 130.25.86.5)
SNMP
Agent
($ZSNMP)
SNMP
Agent
($ZSNMP)
Legend
Request/Response PDUs
$ZTC0
130.25.86.4
Trap PDUs
VST307.vsd