SNMP Configuration and Management Manual

MIBs Supported by the SNMP Agent
SNMP Configuration and Management Manual—424777-006
3-10
RFC Compliance
RFC Compliance
All of the objects described in Table 3-2 comply with the definitions for SNMP group
objects as set forth in RFC 1213, Management Information Base for Network
Management of TCP/IP-Based Internets: MIB-II.
zagInternal Group
The zagInternal group of the SNMP agent’s private MIB is defined by HP and provides
information about the SNMP agent’s internal characteristics. The zagInternal group
consists of objects in these four subgroups:
•
zagInProcess objects, which describe the attributes of the SNMP agent’s process
•
zagInEndpoint objects, which identify the Internet address by which the SNMP
agent can be addressed and the TCP/IP process that handles request/response
messages between managers and the SNMP agent
•
zagInProfile objects, which define the criteria the SNMP agent uses to determine
whether to accept or reject incoming requests from SNMP managers that
communicate with the SNMP agent through TCP/IP
•
zagInTrapdest objects, which define SNMP manager Internet addresses and
TCP/IP processes used by the SNMP agent when routing traps
The SNMP agent provides values for these objects, which are identified by a check
mark in the following list:
iso (1)
identified-organization (3)
dod (6)
internet (1)
private (4)
enterprises (1)
tandem (169)
nonstopsystems (3)
zsmp (155)
zsmpagent (1)
zagInternal (7)
zagInProcess (1)
zagInProcCurrTime (1) √
zagInProcVersion (2) √
zagInProcName (3) √
zagInProcPAID (4) √
zagInProcPrimPID (5) √
zagInProcBkupPID (6) √
zagInProcCreatTime (7) √
zagInProcCpuTime (8) √
zagInProcPri (9) √
zagInProcHomeTerm (10) √