SNMP Configuration and Management Manual

SNMP Agent PTrace Facility
SNMP Configuration and Management Manual—424777-006
6-5
PTrace Commands Supported by the NonStop
Agent
PTrace Commands Supported by the NonStop Agent
The PTrace code consists of two modules. The first module contains the code shared
by all subsystems. The second contains the additional, subsystem-specific code that
actually displays the PTrace records. The following commands implemented by the first
PTrace module are supported by all subsystems:
Additional commands implemented by the subsystem-specific PTrace modules vary
from subsystem to subsystem. Of the commands that fall into the subsystem-
dependent category, the NonStop agent supports the following:
For descriptions of these standard PTrace commands available to all subsystems, refer
to the PTrace Reference Manual. Table 6-1 describes the SELECT command.
PTrace Commands Not Supported by the NonStop Agent
The following subsystem-dependent PTrace commands are not supported by the
NonStop agent:
Subset of Useful NonStop Agent PTrace Commands
Table 6-1 lists and describes a subset of PTrace commands that are particularly useful
when formatting NonStop agent trace records using the PTrace facility. The SELECT
command establishes the criteria against which records are compared. The NEXT and
RECORD commands determine the range of records in the currently opened trace file
that will be examined.
ALLOW FC LIMIT OUT
COUNT FIND LOG PAGESIZE
ENV FROM NEXT RECORD
EXIT HELP OBEY RESET
HEX DETAIL
LABEL SELECT
OCTAL TEXT
EBCDIC TEST
FILTER TRANSLATE
SETTRANSLATE
Table 6-1. Summary of NonStop SNMP Agent PTrace Commands (page 1 of 2)
Command Description
FROM Opens the specified trace file