SNMP Configuration and Management Manual

TCP/IP Subagent
SNMP Configuration and Management Manual—424777-006
8-5
The NonStop TCP/IPv6 Subagent and its Managed
Resources
The NonStop TCP/IPv6 Subagent and its Managed Resources
To run SNMP over TCP/IPv6, you must define the name of a TCP6SAM process. You
can find this process by issuing a LISTDEV TCPIP command to find a process whose
program name ends in TCP6SAM.
If you want to implement Logical Network Partitions (LNPs), you must start an
instance of the SNMP agent for every LNP though which you want to provide SNMP
services.
See the TCP/IPv6 Configuration and Management Manual for information about
starting and using the TCP/IPv6 environment.
Standard MIB-II Groups Supported by the TCP/IP Subagent
The TCP/IP Subagent supports the following MIB-II groups defined in RFC 1213:
These groups, a subset of the MIB-II groups, are identified by a check mark in the
following list:
iso (1)
identified-organization (3)
dod (6)
internet (1)
mgmt (2)
mib-II (1)
system (1)
interfaces (2) √
at (3)
ip (4) √
icmp (5) √
tcp (6) √
udp (7) √
egp (8)
cmot (9)
transmission (10)
snmp (11)
This MIB-II
Group... Provides Information About...
Interfaces Network interfaces of the TCP/IP subsystem being managed
IP Internet Protocol (IP) layer of the TCP/IP subsystem being managed
ICMP Internet Control Message Protocol (ICMP) layer of the TCP/IP
subsystem being managed
TCP Transmission Control Protocol (TCP) layer of the TCP/IP subsystem
being managed
UDP User Datagram Protocol (UDP) layer of the TCP/IP subsystem being
managed