SNMP Configuration and Management Manual

TCP/IP Subagent
SNMP Configuration and Management Manual—424777-006
8-34
MIB Objects
ifPhysAddress
1.3.6.1.2.1.2.2.1.6
read-only
PhysAddress
The interface’s
address at the
protocol layer
immediately below
the network layer in
the protocol stack.
The value depends on the ifType value, as
follows:
ifType
ifPhysAddress
6 (Ethernet) On D series, the
value of ZMFG_ID field of
ZLAM-DDL-INFO-SERV-
8022 structure
6 (Ethernet) On G series (SLSA), the
call LM_Get_Attributes_
on PIF name is used
7 (88023) value of ZINIT_NET-ADDR
field of ZLAM-DDL-INFO-
SERV-8023 structure
9 (tokenring) value of ZNODE-MAC-
ADDR field of ZLAM-
DDL-INFO-SERV-8025
structure
24 (loopback) octet string of 0 length
A SPI INFO command on SUBNET
ztsaTcpIpProcess.* returns a
corresponding TLAM process name. A SPI
INFO command on SERVICE #8022 (for
Ethernet) or 8023 (for SNAP) of the TLAM
process returns current attribute values for
the #L28022 or #L18023 services,
respectively.
ifOperStatus
1.3.6.1.2.1.2.2.1.8
read-only
INTEGER
The current
operational state of
the interface.
The value depends on the contents of the
ZSUBNET-STATE field of the ZTCI-DDL-
STATUS-SUBNET structure, returned from
a SPI STATUS command on SUBNET
ztsaTcpIpProcess.* or LM_Get_Status_
on PIF:
ifOperStatus
ZSUBNET-STATE
1 (up) ZCOM-VAL-SUMSTATE-
STARTED
2 (down) ZCOM-VAL-SUMSTATE-
STOPPED
3 (testing) any other summary state
State 3 (testing) indicates that although the
interface is not in the stopped state, no
operational packets can be passed.
Table 8-5. Interfaces Group Objects Supported by TCP/IP Subagent (page 4 of 7)
Object and
Attributes Definition Format and Derivation of Value