SNMP Configuration and Management Manual

Host Resources Subagent
SNMP Configuration and Management Manual—424777-006
11-10
Configuration
Configuration
You can configure the behavior of the Host Resources Subagent at startup time or
from an SNMP manager after startup. Table 11-1 summarizes the available options.
All subagent attributes that can be controlled by setting MIB object values are
reinitialized when the subagent is restarted to default values or values specified in
startup parameters.
Refer to Starting and Stopping the Subagent on page 11-12 for information on
configuration using RUN startup parameters. Refer to subsequent subsections on
individual MIB groups for information on settable MIB objects.
Table 11-1. Host Resources Subagent Configuration Options (page1of3)
Subagent Attribute
RUN
Startup
Para-
meter
Settable MIB Object
Name (Group Name) Default Behavior
SNMP agent process
name
-a
$ZSNMP on the same
system as the
subagent specified at
startup.
Subagent process
Priority
-n
zhrmSaPri
(zhrmSaProcess group)
Priority is 145.
Backup process
creation
-b
No backup process.
Backup process
takeover
zhrmSwitchToBackupNow
(zhrmSaProcess group)
Backup process takes
over if primary process
fails.
MIB value refresh rate
Hardware configuration
objects
-s
zhrmStableRefreshNow
(zhrmRefresh group)
Values refreshed every
24 hours.
Hardware status and
statistics objects
-d
zhrmDynamRefreshNow
(zhrm Refresh group)
Values refreshed every
10 minutes.
Software objects
-s
-d
zhrmStableRefreshNow
(zhrmRefresh group)
zhrmDynamRefreshNow
(zhrm Refresh group)
Values refreshed
whenever hardware
object values are
refreshed.
MIB values maintained