SNMP Configuration and Management Manual

Host Resources Subagent
SNMP Configuration and Management Manual—424777-006
11-98
Sample Data
Sample Data
Time, zhrmRefreshCurrTime, zhrmDynamRefreshInterval,
zhrmStableRefreshInterval, zhrmLastDynamRefreshTime,
zhrmLastStableRefreshTime, zhrmDynamRefreshCnt, zhrmStableRefreshCnt,
zhrmDynamRefreshNow, zhrmStableRefreshNow
05/22/95 10:29:55, May 22, 1995 10:23:01, 10, 1440, May 22, 1995 10:09:52,
May 21, 1995 17:20:48, 241, 2, autoDynamicRefresh, autoStableRefresh
zhrmRefresh Group Maintenance
The zhrmRefresh group values are updated:
•
At subagent startup time.
•
Whenever MIB values controlled by the -d and -s startup parameters are refreshed.
Refer to Starting and Stopping the Subagent on page 11-12 for a summary of
which MIB values are refreshed when the timers associated with these startup
parameters run down.
•
When a request is received from an SNMP manager to set the value of
zhrmDynamRefreshNow or zhrmStableRefreshNow to 1. After refreshes occur, the
subagent sets the value of these objects back to 0.
zhrmStableRefreshCnt
1.3.6.1.4.1.169.3.180.5.7
read-only
Counter
The number of times
since the subagent
was started that MIB
values controlled by
the -s startup
parameter or the
zhrmStableRefresh
Now object were
refreshed.
Integer without
leading 0s.
Computed by Host
Resources
Subagent.
zhrmDynamRefreshNow
1.3.6.1.4.1.169.3.180.5.8
read-write
INTEGER {
autoDynamicRefresh(0),
forceDynamicRefresh(1) }
When set to 1 (force
DynamicRefresh)MIB
objects whose values
are controlled by the
-d startup parameter
are refreshed.
One of these values
is displayed:
autoDynamic
Refresh
forceDynamicRefresh
When setting these
values, use 0 or 1.
Initialized to 0
(autoDynamicRefres
h) at startup, but can
be changed from an
SNMP manager.
zhrmStableRefreshNow
1.3.6.1.4.1.169.3.180.5.9
read-write
INTEGER {
autoStableRefresh(0),
forceStableRefresh(1) }
When set to 1
(forceStableRefresh),
MIB objects whose
values are controlled
by the -s startup
parameter are
refreshed.
One of these values
is displayed:
autoStableRefresh
forceStableRefresh
When setting these
values, use 0 or 1.
Initialized to 0
(autoStableRefresh)
at startup, but can be
changed from an
SNMP manager.
Table 11-16. zhrmRefresh Group Objects Supported by Host Resources
Subagent's MIB (page 2 of 2)
Object and Attributes Definition Format of Value Derivation of Value