SNMP Configuration and Management Manual

Trap Multiplexer Subagent/Manager
SNMP Configuration and Management Manual—424777-006
12-46
105: ZTMX-EVT-TMX--PROG-ERR
Recovery. Try using another disk as a swap device. If the problem persists, contact
your service provider and provide all relevant information as follows:
•
Descriptions of the problem and accompanying symptoms
•
Details from the message or messages generated
•
Supporting documentation such as Event Management Service (EMS) logs
If your local operating procedures require contacting the GCSC, supply your system
number and the numbers and versions of all related products as well.
Sample Message
96-07-26 11:48:59 \COMM.$ZTMX TANDEM.TRAPMUX.D31 000104 Transient
Fault - SNMP-Trap-Multiplexer \COMM.$ZTMX,
event number: Process-No-Memory-Space,
fault type: Memory-full
105: ZTMX-EVT-TMX--PROG-ERR
The Trap Multiplexer process experienced an internal or logic error.
ZTMX-TKN-SUBJ-TMX
identifies the subject of the event (always the Trap Multiplexer process). The DDL
heading of this token (“SNMP-Trap-Multiplexer”) and the token’s value (the name
of the process) are inserted in the message text.
ZTMX-EVT-TMX-PROG-ERR
is the event number (105). The DDL AS clause of this value (“Process-Internal-
Error”) is inserted in the message text following “event number:”
ZTMX-VAL-TF-PROG
identifies the type of transient fault that occurred. For this event, the DDL heading
of the value (“Internal-error”) is inserted in the message text.
Unconditional Tokens
ZTMX-TKN-SUBJ-TMX
ZEMS-TKN-EVENTNUMBER
ZEMS-TKN-TXFAULT-TYPE
Value
<1> Trap Multiplexer process
name
<2> ZTMX-EVT-TMX-PROG-ERR
<3> ZTMX-VAL-TF-PROG
Conditional Tokens
ZTMX-TKN-ERR-TEXT
Value
<4> descriptive text
Message Text
Transient Fault - SNMP-Trap-Multiplexer <1>, event number:
<2>, fault type: <3>, error detail: <4>