SNMP Configuration and Management Manual

Ethernet Subagent
SNMP Configuration and Management Manual—424777-006
14-17
State Object/Resource Object Pairs
Table 14-4 lists the resource objects and their associated state objects and state
values.
State objects cannot be set to “Connected” and “Disconnected” with a Set request;
these objects are internally generated states indicating the state of the connection
between the Ethernet Subagent process and the process represented by the resource
object. “Disabled” and “Enabled” are SNMP Set request-generated states used when
resource objects are being reconfigured.
The meanings of each state is as follows:
Table 14-4. Ethernet Subagent State Object/Resource Object Pairs
The operational state of
this resource object...
Is indicated or controlled
by this state object...
Which may contain one of the
following states...
zesaAgentName zesaAgentState Connected (1)
Disconnected (2)
zesaBackupCPU
zesaBackupPIN
zesaBackupState Connected (1)
Disconnected (2)
Disabled (3)
Enabled (4)
zesaTcpIpProcess zesaTcpIpState Connected (1)
Disconnected (2)
Disabled (3)
Enabled (4)
zesaEmsCollectorName zesaEmsCollectorState Connected (1)
Disconnected (2)
Disabled (3)
Enabled (4)
Connected The subagent is functioning normally.
Disconnected Subagent function dependent on the process or interface is not
available.
Enabled The subagent will immediately attempt to establish connections
with the process or interface.
Disabled The process or interface has been taken out of service explicitly
by an operator.