SNMP Configuration and Management Manual

Ethernet Subagent
SNMP Configuration and Management Manual—424777-006
14-30
EMS Support
EMS Support
This subsection describes the Event Management Service (EMS) events, listed in
Table 14-8, generated by the Ethernet Subagent (subsystem abbreviation ZESA).
Table 14-8. Ethernet Subagent Event Messages (page 1 of 2)
Number ZESA-EVT- Standard Event and Description
3001 SUBAGENT-AVAIL Object Available
The Ethernet Subagent process
(zesaProcessName) has completed process
initialization after initial startup or after a
takeover by the backup process.
3002 SUBAGENT-UNAVAIL Object Unavailable
The Ethernet Subagent process is terminating
for reasons other than an internal fault or
invalid startup configuration.
3003 AGENT-OBJ-AVAIL Object Available
The configured SNMP agent process
(zesaAgentName) has transitioned into the
“connected” state.
3004 AGENT-OBJ-UNAVAIL Object Unavailable
The configured SNMP agent process has
transitioned into the “disconnected” state.
3005 BACKUP-OBJ-AVAIL Object Available
The Ethernet Subagent backup process has
transitioned into the “connected” state.
3006 BACKUP-OBJ-UNAVAIL Object Unavailable
The Ethernet Subagent backup process has
transitioned from the “connected” state into
the “disconnected” or “disabled” state.
3007 EMSCOLL-AVAIL Object Available
The configured EMS collector process
(zesaEmsCollectorName) has transitioned
into the “connected” state.
3008 EMSCOLL-UNAVAIL Object Unavailable
The configured EMS collector process has
transitioned into the “disconnected” state.
3009 TCPIP-OBJ-AVAIL Object Available
The configured TCP/IP process
(zesaTcpIpProcess) interface has transitioned
into a “connected” state.