SNMP Configuration and Management Manual

Ethernet Subagent
SNMP Configuration and Management Manual—424777-006
14-44
3005: ZESA-EVT-BACKUP-OBJ-AVAIL
ZEMS-VAL-reason
indicates the reason the backup Ethernet Subagent process has become available.
The DDL AS clause associated with this value is inserted in the message text
following “reason.”
ZESA-VAL-STATE-state
indicates the previous state of the backup Ethernet Subagent process. The DDL
AS clause associated with this value is inserted in the message text following
“previous state.”
ZESA-VAL-STATE-CONNECTED
indicates the current state of the backup Ethernet Subagent process. The DDL AS
clause of this value (“connected,” defined above) appears in the message text
following “current state.”
ZEMS-VAL-NULL
indicates the type of subsystem defined event. Because the Ethernet Subagent
process has not defined this as a private event, the DDL AS clause “undefined”
always appears in the message text following “user content.”
Value of
ZEMS-TKN-CHANGE-REASON
Associated Text (DDL AS Clause) and
Meaning
ZEMS-VAL-UNDERLYING-UP “underlying-serv-up” indicates that the backup
Ethernet Subagent process is available
because an underlying resource on which it
depends has become available.
ZEMS-VAL-OPERATOR-INITIATED “operator-initiated” indicates that an operator
has brought the backup Ethernet Subagent
process up by setting the zesaBackupState
MIB object to “enabled.”
Value of
ZEMS-TKN-STATE-PREVIOUS Associated Text (DDL AS Clause)
ZESA-VAL-STATE-CONNECTED “connected” indicates a normal operational
state.
ZESA-VAL-STATE-DISCONNECTED “disconnected” indicates a nonoperational
state where subagent function dependent on
the interface was not available.
ZESA-VAL-STATE-ENABLED “enabled” indicates that the process was set
by an operator such that the subagent would
immediately attempt to restore it to a
connected state.
ZESA-VAL-STATE-DISABLED “disabled” indicates that the process had
been taken out of service explicitly by an
operator setting the zesaBackupState MIB
object to “disabled.”