SNMP Configuration and Management Manual

Ethernet Subagent
SNMP Configuration and Management Manual—424777-006
14-50
3007: ZESA-EVT-EMSCOLL-AVAIL
ZESA-VAL-STATE-state
indicates the previous state of the interface to the EMS collector process. The DDL
AS clause associated with this value is inserted in the message text following
“previous state.”
ZESA-VAL-STATE-CONNECTED
Indicates the current state of the interface between the EMS collector process and
the Ethernet Subagent. The DDL AS clause of this value (“connected,” defined
above) appears in the message text following “current state.”
ZEMS-VAL-NULL
Indicates the type of subsystem defined event. Because the Ethernet Subagent
process has not defined this as a private event, the DDL AS clause “undefined”
always appears in the message text following “user content.”
Cause. The subagent acquired or reacquired its connection to the configured EMS
collector process (zesaEmsCollectorName).
Effect. Subsequent events generated by the subagent will be sent to the configured
EMS collector.
Recovery. Informational message only; no corrective action is needed.
Value of
ZEMS-TKN-STATE-PREVIOUS Associated Text (DDL AS Clause)
ZESA-VAL-STATE-CONNECTED “connected” indicates a normal operational
interface between the EMS collector and the
subagent.
ZESA-VAL-STATE-DISCONNECTED “disconnected” indicates a nonoperational
state such that subagent function dependent
on the interface is not available.
ZESA-VAL-STATE-ENABLED “enabled” indicates that the interface had
been set by an operator such that the
subagent will immediately attempt to restore it
to a connected state.
ZESA-VAL-STATE-DISABLED “disabled” indicates that the interface had
been taken out of service explicitly by an
operator setting the zesaEmsCollectorState
MIB object to “disabled.”